| Solution: |
The
freezing is caused by multiple
display adapters being loaded on boot-up. In most cases When using a
FlashPoint™
framegrabber, you will need to disable or remove additional video
adapters,
including any built-in display adapters and remote desktop sharing
(e.g.
Microsoft SMS). You can remove the board to start Windows or enter
Windows
in Safe Mode. Then disable the display adapters from the Device Manager
- make sure you leave the S3 Savage adapter enabled (this is the
FlashPoint
board's display adapter). Afterwards, shut down the computer and
reinsert
the framegrabber, if you removed the board. Next you will need to load
the drivers for the framegrabber
and run the FlashPoint setup software - see the framegrabber's
installation
manual for instructions on how to do this.
|
